Wireless TV Speakers – Setting Up the Transmitter

Setting up home theatre speakers is quite frustrating especially when having to look for all the right ports. rnDespite instructions though, it basically boils down to trial and error. Fortunately this is not the same thing when it comes to wireless TV speakers. Setting them up only means dealing with the transmitter and the receiver. Below are simple instructions on setting up the transmitter for the wireless TV speakers. 1. Insert the right red speaker wire to the red terminal of the home amplifier. Do the same thing with the black terminals. That should now connect the right speakers to the home theatre amplifier properly. 2. Now, connect the left red speaker wire to the red terminal of the home amplifier. Do the same with the black terminals. That should now connect the left speakers to the home theatre amplifier. 3. Connect the other end of the right speaker cord of the wireless speaker system into the red terminal. Insert the other end of the right black speaker wire to the black terminal. 4. Connect the other end of the left speaker cord to the wireless speaker system into the red terminal. Insert the other end of the left black speaker wire to the black terminal. 5. Plug in the AC adapter and connect the other end to the transmitter power socket. 6. Set up the wireless transmitter either on the wall or on a flat surface. Make sure that there is nothing that will obstruct the transmission of the signal from the transmitter for any blocks can prevent smooth transmissions of signals to the wireless receiver. 7. Check out if everything works and make sure all cords are in their right terminals. Make sure the connections are tight. After checking out everything, it is now time to set up the wireless receiver which will receive the signal from the transmitter. Again, there may be some confusion to which terminal goes with which wire so read the manual carefully. Good luck!